Hard Lid Design concept

bay window bandit · Post by **bay window bandit** » Mon Jul 05, 2010 11:24 am

Nice work Tonz, it's looking really good. You should do a mould and sell fibreglass versions of it.

Tonz Magonz · Post by **Tonz Magonz** » Mon Jul 05, 2010 12:52 pm

May do....

Not sure about the demand versus cost, issue though...

Would need a Dub loving 'Glasser to come on board...

Shaven · Post by **Shaven** » Mon Jul 05, 2010 10:46 pm

Tonz Magonz wrote:May do....

Not sure about the demand versus cost, issue though...

Would need a Dub loving 'Glasser to come on board...

SC's are common... i dont see the problem

Tonz Magonz · Post by **Tonz Magonz** » Tue Jul 06, 2010 8:32 am

Shaven wrote:
Tonz Magonz wrote:May do....

Not sure about the demand versus cost, issue though...

Would need a Dub loving 'Glasser to come on board...
SC's are common... i dont see the problem

Good point....

Would consider creating one for a DC at a reduced rate....
Less material due to the smaller tray.....
Has anyone ever mentioned to you Matty ,that the tray was smaller....?
Not sure if you had noticed...

Hoves · Post by **Hoves** » Tue Jul 06, 2010 10:15 am

Tonz Magonz wrote:
Shaven wrote:
Tonz Magonz wrote:May do....

Not sure about the demand versus cost, issue though...

Would need a Dub loving 'Glasser to come on board...
SC's are common... i dont see the problem
Good point....

Would consider creating one for a DC at a reduced rate....
Less material due to the smaller tray.....
Has anyone ever mentioned to you Matty ,that the tray was smaller....?
Not sure if you had noticed...

Shaven · Post by **Shaven** » Wed Jul 07, 2010 11:17 pm

ive been told things are small for years

... you must have self belief & the power of the little man

GFresh · Post by **GFresh** » Thu Jul 08, 2010 9:33 am

Sorry Tonz

I did a rough measurement of the timer planks last night and they are about 1600 long and 70 wide by 10 thick

How many would you need?

I can bring them to work tomorrow for you to collect / view if you like

I will be at work till 6 pm

Tonz Magonz · Post by **Tonz Magonz** » Fri Jul 09, 2010 8:56 am

GFresh wrote:Sorry Tonz

I did a rough measurement of the timer planks last night and they are about 1600 long and 70 wide by 10 thick

How many would you need?

I can bring them to work tomorrow for you to collect / view if you like

I will be at work till 6 pm

Sounds like worth a try ...Length might be fine...
I can collect from your work this arvo if you have planks with you
Sorry didnt get on DSK until this morning...

Was out in the shed last night until late..using a Mig is an expensive way to keep the body warm..

Pics below of the corner treatment behind the cab....

This is version 2...The first attempt was cut off and the original metal had to be reinstated and rewelded after 2-3 hours work with version 1 ....

Drivers side done and now working to finish passenger side...

Hard Lid Design concept

.

Re: .