www.dsk.com.au

looking for the easiest way of putting in a 1600 and straight axle in splitty any body give me some good detail about putting in a 1600 twin port in a 50s split what is the best doner for this and straight axle how do i do this?will this engine bolt to my old gear box? if not what doner gear box should i use

you will have to clearance the stock gearbox for 1600 motor only a little so flywheel fits, straight axle on an early bus is a bit more involved as the gearbox mount is different to later splits.
about to do this aswell to a 57 so will put pics up. KCW and The Samba are your friends

You need a pre 65 type 3 gearbox, has wide 5 and the bigger brakes then buy the straight axle kit off Bernie ( deluxehunter on here ) cut the shock mounts off put the nose cone off the split bus gearbox onto the type 3 box then bolt her straight in ( early splits nose cone is different ) what year is yours ?

i just did this to my 55.if yours is in the 50s it is a bit harder than after 60.s are,yep need the newer split nose cone and hockey stick to mount on the gearbox.
then you have to make or buy the nose cone mount...about 80bucks is solid steel and was told by a few people that it creats a fair bit of noise..i made one up it was easy and i got a cut of of po polyurathane to use as the spacer.

can try find a few pics if you want.

i used burnies kit took 5 mins to put in.

use any swing box you really need the long axle long spline so you can run the type 3 drums or bug disc conversion. type 3's just have a better freeway ratio and wide 5 till 1968. you can use bug wide 5 but need a spacer on the axle spline under the nut which is a bit dodgy and the drums are smaller, or machine the snout off the split drums.

thanks for the help yeah startinh to get a handle on this. how do i find Bernis email or phone to get the kit? i like the photo scotty 85 whos the girrrl?

yeah the kombi is a 1956 so i guess it will be a bit harder. might just put a 1600 engine in with the old gear box for rego then do more mods afterwards

yeah it took me awhile to work it all out aswell

waiting to see if it was worth all the hasel.

viewtopic.php?t=9316
this is a link to burnies add for the stuff

its kate moss

Nice avatar Scotty

Well heres an idea dont do it ! IRS it instead ive had 2 straight axle buses and that set up sucks ass.Go for indian autos bolt in kit

Why did it suck

I did the the IRS rear with single side plate bug box into my 66 with the 1600 and with a 4'' narrowed disc brake ball joint front end and it drives a treat. Very little problems at all.

Cheers.

I've driven my straight axle bus daily and fkn great , you must have had it set up wrong . or not low enough .
Were you running a nice front end ie drop or flipped spindles or trying to run with adjusters set low with 50 series tyres ?

Does this stop the wheels from wanting to tuck under when cornering? ie can you push the car a bit harder around bends?

ive never driven a straight axle, however id like to compare, mine is irs and corners schweet..