www.dsk.com.au

Here is my bus in its sad state, has been in my driveway for 2 years like this.
I have built a carport over it and have started cleaning and will start cutting soon.

a bit more

Nice.. Look forward to seeing this progress.

Awesome patina!

this what ive cut so far not sure how high to go with cut to replace corner, probably obove the beltline where it is creased.
pretty much the only gutter rust....... so far

got this replacement corner from 'animal' also he sent a section to sort the part of arch i removed. thanks mate can anyone tell me the best way to straighten the panel that holds the the engine lid hinges, if you can look closely on the rear shot it shows it kicking up on the right handside where that whole corner was messed up.

Hi Mate,

I have a similar looking project going at the moment. Where abouts are you located?

Luke

Hi Luke Im in North Western Sydney.
What have you got going?

Andrew

been trying my hand at panel beating, bit crap but hopefully will learn slowly.
have taken big dent out of front but left with the smaller 'oil canning' number you can see here. also the line of front window on passenger side is bent if you look closely replacement peice for arch and finally question about my cargo doors, any tips on straightenting out bottom edge would be appreciated. van was dragged on ground without wheels at some stage and doors suffered.

I have a boronia brown in Newcastle.

viewtopic.php?f=7&t=17923&hilit=boronia+brown

Hey Luke
I have seen that one before, looks great and very complete.
your miles ahead of me, mustnt be far off rego?

you could have pushed that corner dent out as vw steel is great to work with , atleast its easy to get to the spot welds once you get corner back on

your probably right klause......
need your skills

big hammer and port a power and contemplation time of how it was hit so you can reverse it

Nice work Andrew,happy to help out mate.