Fitting Red9 running gear

[Karmann70]

I am looking to install Red9 front and rear suspension to my 65 Microbus. Is there anyone on this forum who has done this and can offer suggestions and do's and dont's ?. Any help, suggestions or comments would be much appreciated.

[kombi niko]

Al's your man at desresto in Qld to talk too.

[Karmann70]

Al's your man at desresto in Qld to talk too.

Thank's for your help. Already have the gear from Das resto and ready to fit it. Was looking for comments from someone else who may have fitted it other than Das resto for any alternative comments, good, bad or just helpful.

[kombi niko]

Right o , you going down the engineer route?

[Karmann70]

Right o , you going down the engineer route?

Is already registered but intend to have it engineered as well.

[63 left hooker]

Where are you located?

[Karmann70]

Where are you located?

Country SA

[kombi niko]

could be a hard one to get passed, I would look into it first.

[d_jammer]

have a search through the uk SSVC forums. Seems to be a common upgrade over there.

[067DUB]

could be a hard one to get passed, I would look into it first.

Das has an engineer to sign it off in Qld

[kombi niko]

but hes in SA, differen't rules yes?

[067DUB]

but hes in SA, differen't rules yes?

True, a call to Al or Steve will be best.

[D-Train]

even bierdoc, hes fitted one by himself

[kombi niko]

fitting a front end is pretty easy just a bolt on unit its getting it passed if your not in Qld is the hard bit.

[Cam Biscuit]

Mark Poole in Edwardstown would be worth calling. MP Motorsport

I think he may have done this install before and has engineering contacts.