58 11 window " The Cubby Hut "

[vanell]

That seems about right, roughly around 70 mm to 75 each, gap between 3 and 4 the way I measured it was 75 mm and the 4 to corner was 70, 33 each to the seam, thereabouts, but it would be nice to be exact

[vanell]

Worked on the front today, cut about 100mm off al the bottom and replaced it,still have to finish welding tommorrow

[vanell]

Also started on the dash, in two minds on which way to go with it, I like it with the middle filled in and the outside two speaker grilles, putting speakers behind thats why I made it 9 grills each

IMG_1854.JPG (40.53 KiB) Viewed 3386 times

IMG_1853.JPG (41.21 KiB) Viewed 3386 times

[Leroy]

Love it!!

[braddick]

Nice one Ian
Keep up the good work

[vanell]

ok here is the project, CH58645511215W, so thats Cubby Hut 58model 64 roof 55 front 11 window to 15 window, just got to weld it all up !

IMG_1857.JPG (41.91 KiB) Viewed 3363 times

IMG_1855.JPG (40.92 KiB) Viewed 3363 times

IMG_1858.JPG (42.55 KiB) Viewed 3363 times

[jvm]

It looks like an exploded diagram in the photos above

Great work, you're knocking it out of the park

[vanell]

Today I did a 25mm steering box raise, and welded up some crusty bits, also I have moved the coloumn over 25mm because I moved the pod over 25mm to the right, to get the extra speaker grilles in an also when I had my single cab I always felt the coloumn was a bit towards the centre, any way just my preferance, and no extra work involved as there was no pod there anyway, more than likely wouldnt have done it if the whole dash was there. first picture after

IMG_1863.JPG (40.7 KiB) Viewed 3352 times

IMG_1862.JPG (41.18 KiB) Viewed 3352 times

I have no idea why they are sideways! dont know how to fix it just turn your head

[vanell]

My idea on putting this roof on is to cut the outside lip an the inside brace off the cabin, leaving the flat piece with the inside lip, then cutting the inside lip off the new roof and sandwitch them together, weld the b pillars back together and I will have to weld at the back hatch, it will only be 1mm higher this way and i dont think you will notice it and I dont have to unpick the whole roof, sounds easy, going to have a go at it next week

IMG_1864.JPG (36.95 KiB) Viewed 3352 times

[MID WEST DUBBER]

Big project but looking good, keen for more updates

[Cam Biscuit]

You have big balls!

[vanell]

Been working on the roof, cut the outer lip off the cabin, and the inner lip off the roof, lots of grinding, trial fit looks good, now prepping the two surfaces, going to glue it and spot weld it.

IMG_1894.JPG (27.04 KiB) Viewed 3274 times

IMG_1905.JPG (30.75 KiB) Viewed 3274 times

IMG_1893.JPG (33.14 KiB) Viewed 3274 times

[Leroy]

This build is unreal!! Loving seeing this thing come together Ian. Keep it up mate.

[StevieVW]

Keep the pics coming to get me motivated to start my similar 11 window!

[rabidkombi]

That's inspirational work,love it