60 panel

[warb]

dolly done, looks the goods , subfloor on its way next week.. question is, should we do the lower seperator panel before installing the subfloor? looks like the front top hats go over the seperator panel at the bottom..

Got a pic of what you mean mate? I think your asking about the bottom of the bulkhead which sits on the front of the front top hat and is below floor level? If so you can do the sides after the top hats and floor but the centre section (under the spare wheel section) needs to be done before floor as that’s where floor butts up against.

exactly mate, and tha thats what im doing, will most likely remove the lower bulkhead panel as its a hack job, install subfloor, than a new lower bulkhead when i get it.. the way i see it is the cargo floor welds to the bulkhead, not the forward tophat. however will be doing some more study, look over my yellow bus too.. always learning. BTW,pre assembled floor looks the goods so far.

[spl65t]

Nice one mate, remind me is it the red over the blue or vice versa ?

[warb]

Nice one mate, remind me is it the red over the blue or vice versa ?

Blue over red, may have been PMG, however none of the tell tale bits/holes. However has the weights on the drivers sill.. dunno.

[D-Train]

Pre gabbed floor looks good. Who’s one is that?

[warb]

Pre gabbed floor looks good. Who’s one is that?

BBT through allaircooled, looks solid and size looks correct, spacing of i beams and tophats are within a few mm, comes with the outriggers too..will strip back the primer to sus too, so far so good tho

[D-Train]

Fuxk yeah. Looks good

[warb]

postman dropped off some goodies..

[splitthis]

Let the fun begin!

[D-Train]

Does the KF lower bulkhead not have the cutouts for the gear tube in the middle, or doesn’t it go down that far?

[warb]

Does the KF lower bulkhead not have the cutouts for the gear tube in the middle, or doesn’t it go down that far?

I have absolutely no idea, we're getting into it next Sunday maybe hopefully, let you know then mate!

[D-Train]

Does the KF lower bulkhead not have the cutouts for the gear tube in the middle, or doesn’t it go down that far?

I have absolutely no idea, we're getting into it next Sunday maybe hopefully, let you know then mate!

Epic! Thanks bloke!

[beerdoc]

Ha, thinking of putting in a type3 hatch, dunno, have the panel to close up the hole tho...

Do the hatch Warby Trust me well worth it

[warb]

Ha, thinking of putting in a type3 hatch, dunno, have the panel to close up the hole tho...

Do the hatch Warby Trust me well worth it

deal being done as i type

[MID WEST DUBBER]

Ha, thinking of putting in a type3 hatch, dunno, have the panel to close up the hole tho...

Do the hatch Warby Trust me well worth it

deal being done as i type

149845504_428304705064431_1325597932861335195_n.jpg

I was thinking about this for my bus as well

[warb]

another peice of the puzzle.