Ian’s Dual Cab

[spl65t]

Damn, this is next level surgery….. Dr

[Kombiiknut]

You really are fucking bonkers

[Beatts]

The Wizard at his best

[griffiths_r]

You really are fucking bonkers

But so impressive at the same time.

[vanell]

Had a few days back on this, got a new toy, a laser level and it’s working out a treat

IMG_8748.jpeg (78.95 KiB) Viewed 4760 times

IMG_8747.jpeg (81.35 KiB) Viewed 4760 times

[vanell]

Also going to have a go at saving the Panel Van front piece, it’s a bit rusty but I’m going to use it, I’ll be trying to use a lot of s/hand pieces on this, don’t want it rusty but do want it old looking

IMG_8758.jpeg (135.26 KiB) Viewed 4759 times

[vanell]

Doors test fitted, and some old single cab gates cut down

IMG_8764.jpeg (108.62 KiB) Viewed 4704 times

IMG_8763.jpeg (120.86 KiB) Viewed 4704 times

IMG_8762.jpeg (100.08 KiB) Viewed 4704 times

IMG_8768.jpeg (137.92 KiB) Viewed 4704 times

[Snebo67]

Rusty Gold Wiz, you're making great progress on this.
Valla bound!!!!

[vanell]

Yep, Valla bound, huge statement but it’s good to have a goal

[MID WEST DUBBER]

Looking good Ian, laser is a great new addition for you

[vanell]

Thanks Rusty, I have it set up to the roof gutters, have put marks on the walls around the garage so you can move the laser from side to side, perfect in the house garage were you can turn the lights off, certainly not great in the day light , I think it is accurate enough within 1or 2 mm, game changer for me
The roof gutters, load bed, doglegs and toolbox are all on the same plane, as in all are level, and the cabin seams and bulkhead are all 90 degrees to that
I actually think it would be now easier to make one from scratch instead of cleaning up rusty stuff, how you go about getting it registered well that’s another story

[Griffin]

I actually think it would be now easier to make one from scratch instead of cleaning up rusty stuff, how you go about getting it registered well that’s another story

Im just building a pallet to send a new chassis and all panels to build a bus to New Zealand so yes its happening...

[Kombiiknut]

That's wild Wiz, bloody awesome

[vanell]

Cargo door in the hole, fits quite good

IMG_8785.jpeg (129.92 KiB) Viewed 4426 times

[vanell]

First test fit of the front panel, not quite right yet don’t think I have the tops of the A pillars in the right spot yet

IMG_8783.jpeg (109.73 KiB) Viewed 4425 times