58 mingo mango

[rusty 55]

I know a guy with a killer OG paint PG SG…..

Yes so do I, but dose he have a back seat

Nah don’t think he does, although it would look killer!
I also think the money for a seat if he had it (doubtful) could be better spent on a motor!

[rusty 55]

That is coming up sweet Brad, seats look great and comfy, I look forward to testing them out. Interior panels look killer too awesome job mate

[braddick]

Making progress
Back seat finished off
Back rest of front seat done, damm that was a tight fit

IMG_4608.jpeg (213.63 KiB) Viewed 3091 times

IMG_4609.jpeg (204.08 KiB) Viewed 3091 times

IMG_4610.jpeg (160.69 KiB) Viewed 3091 times

IMG_4611.jpeg (182.04 KiB) Viewed 3091 times

Now the tricky one, that’s had a few mods done the bottom of the front seat

[Beatts]

Hey Brad would my rear board out of the 67 work? It’s crusty enough.

I’ll send a photo when I’m at the shed next.

[braddick]

Hey Brad would my rear board out of the 67 work? It’s crusty enough.

I’ll send a photo when I’m at the shed next.

Thanks mate
I did end up making one ( which I’ve forgot to get a pic of)
But og is og so I’m keen

[braddick]

I know a guy with a killer OG paint PG SG…..

Yes so do I, but dose he have a back seat

Nah don’t think he does, although it would look killer!
I also think the money for a seat if he had it (doubtful) could be better spent on a motor!

Na back seat is pretty important for your mates in the back

[MID WEST DUBBER]

Seats are looking great Brad

[morts]

Interior looks great Brad - when do you reckon you'll be trucking along the Dukes??

[braddick]

Font seat finished off
Unfortunately no pic of it in the front
Things seem a bit tight on getting it to fit, might need some lube
And I might of overlooked a wheel tub / seat spring mod
Will investigate tonight

IMG_4619.jpeg (283.62 KiB) Viewed 3055 times

IMG_4620.jpeg (245.63 KiB) Viewed 3055 times

[rusty 55]

Use a heat gun to warm up the vinyl to help stretch it, be careful not to burn it by keeping the gun moving
Looking great tho mate, can’t wait to go for a spin in it

[braddick]

Seat installed
Tighter fit because of the slightly raised mounting point
I did test fit the frames when I made them yrs back but unfortunately didn’t test fit with the springs installed as well.
And overlooked the the fact that springs would be bottoming out on the tubs and wouldn’t sit completely flush on the rubber stoppers
Lucky for me once 90kg is on them we have a nice fit

IMG_4630.jpeg (190.19 KiB) Viewed 3028 times

IMG_4629.jpeg (223.73 KiB) Viewed 3028 times

IMG_4632.jpeg (107.49 KiB) Viewed 3028 times

[braddick]

Had to see how the back seat looked in the back
Bit of work to do the lower heater log board

IMG_4636.jpeg (208.08 KiB) Viewed 3017 times

[Kombiiknut]

Niiiiiiiiiiice..

[Perik57Splitty]

Nice work Brad… looks awesome!

[spl65t]

Now that’s looking cosy. So cool !!!
Another bus I look forward to seeing on the road one day.