65 Single Cab

[splitthis]

Does the transporter only do OG paint?

[vanell]

Day 4, gates on , rear finished

IMG_5804.jpeg (198.63 KiB) Viewed 1856 times

IMG_9805.jpeg (112.01 KiB) Viewed 1856 times

[Oldfart]

Will you weld the bed sheets together before you glue/bond the floor down?

Geez mate , you were going to do this last November!

Making a living has intervened, with luck the coming summer will see progress.

So........weld the four floor pieces together of just glue them all together when the floor is bonded down?

[vanell]

Just glue the 4 pieces on separately, you can do 2 at a time if you like
Just have a trial fit before hand working out the way they go together and put a couple of screws in them so you have a reference point when they go back together
Epoxy prime them and seam seal the joints

[Oldfart]

Thanks. In the olden days they would have been plug braised (Before TIG/Mig was used much in panel work), finish up with a lot of cleaning up and burnt paint, Bonding seems a lot neater way of going about it.

[Kombiiknut]

Awesomeness....

[vanell]

Day 5 Repaired the broken hinge on the Driver Side door and fitted it, so the panel side of it is done
Fitted the front end and gearbox
Pick up tyres tomorrow

IMG_9810.jpeg (108.45 KiB) Viewed 1707 times

[Griffin]

sweet ride

[Snebo67]

Drive it home Wiz!

[Kombiiknut]

Day 5 Repaired the broken hinge on the Driver Side door and fitted it, so the panel side of it is done
Fitted the front end and gearbox
Pick up tyres tomorrow IMG_9810.jpeg

Farkenel... Well done mate.

[vanell]

Day 6, done, it’s a roller and going to the transport company tomorrow

IMG_9814.jpeg (144.11 KiB) Viewed 1545 times

IMG_9815.jpeg (145.47 KiB) Viewed 1545 times

[Snebo67]

Lost for words, great stuff Wiz, looking forward to seeing it back in SA.

[spl65t]

Fk'n Terminator !!!

[vanell]

Gone to the Transport Company

IMG_9824.jpeg (137.11 KiB) Viewed 1463 times

[Kombiiknut]

Well done Wiz.. Great to watch