65 Single Cab

[Beatts]

No problems there, Wiz already has a lineup.

Take a number please!

[vanell]

Bulkhead in , floor welded in and tank separation panels almost done, have a new late model one and a rusty early one, guess I’ll have to get another one either early or late to make them both the same, maybe fit the fuel tank tomorrow

IMG_9989.jpeg (136.17 KiB) Viewed 676 times

IMG_9990.jpeg (105.21 KiB) Viewed 676 times

[rusty 55]

Looks brand new in there Wiz, except the divider obviously!
All that OG paint is looking great too

[vanell]

Beatts spot welded these braces on for me, and the drivers side is almost done

IMG_0011.jpeg (116.29 KiB) Viewed 249 times

IMG_0017.jpeg (127.64 KiB) Viewed 249 times

[Beatts]

Joint effort Wiz.

I just did the foot work, while you zigged, zagged and pivoted around.

[vanell]

Back on this today
Patch up on the A pillars, fix the thread plates for the door hinges, test fit for the floor patches and front valance

IMG_0065.jpeg (134.63 KiB) Viewed 103 times

[vanell]

Front panel had a lot of bog in it, so I just cut out the bad stuff and am using the front nose piece from my Dual Cab
Badge helps to line it all up

IMG_0066.jpeg (178.16 KiB) Viewed 103 times

IMG_0067.jpeg (211.42 KiB) Viewed 103 times

[Griffin]

Wiz - I have an early rusty divider panel,,,,