OOPS another Dc early 62

[Dibsy]

But what are you going to do in a fortnight when it's finished ?

[FrankenCab]

Have a few choices

[FrankenCab]

Rear torsion cleaned up and welded in now on to the front

[FrankenCab]

And the front

[kombiing]

OMG you aren't fookin around!, nice one klaus tearing into it good to see

[FrankenCab]

Here's what 2 -3 hours of drilling and welding get you ..2 broken beam bolts removed ..being high tensile steel ie fkn hard had to re sharpen masonry bit so it would drill this out and oxy heat bolts up then drill holes right thru then weld too ..fun fun

[kombi niko]

I so Hate broken bolts and anything to do with them!!

[kombibob]

awesome work as usual, when its finished you need to come up to Noosa with your welder for a holiday

[FrankenCab]

Got a few more to remove but this one was the hardest one so far to get out , that old pat bus is all yours bob haha

[FrankenCab]

Finally got front sitting right , within a 1mm , so will push a few more dents out while I have easy access bolt a beam up and weld it in place

[FrankenCab]

Just about finished of a 2 inch narrowed beam just need to ream centre pin bushes

[okrasa power]

well done mate, you are awesome!!

Saved another one from the scrappers.

[FrankenCab]

Lhf pillar going back in after hammer abuse

[FrankenCab]

Here's some front shots before it was delivered

[FrankenCab]

Bit of sill work